Mark Small Machine Inc

Reviews

Reviews are sorted by relevance, with the most helpful and insightful feedback listed first for easy reference.

  Ronald Chernek
7 months ago
Took Mark a relatively small machining job. Needed two drum brake wheel hubs turned and chamfered on the OD of the wheel mounting flange, and the wheel studs upgraded to 1/2" studs that I supplied. Also had two disc rotors I needed turned and surfaced. Parts where for there for roughly a week when I got a call asking if the rotors were supposed to fit on the hubs. This is where I got a bad feeling in my gut. Yes, the rotors should fit the hubs. They did perfectly before i dropped them off. Mark informed me they didn't fit, and the holes in the rotors would need enlarged. I agreed to a minimum amount of material being removed, but didn't understand why this was needed. Went to the shop the following morning to pick up my parts, and the feeling in my gut worsened. Looking at the hubs it was obvious to the naked eye the new wheel studs were not installed correctly, not even close to perpendicular to the wheel mounting surface as required. I had taken a wheel bolt pattern gauge with me, and it wouldn't even start over the reduced diameter on the end of the studs. Pointing this out it was suggested I torque the studs(they're knurled press fit) to straighten them out. Getting the parts back to my shop and checking the studs with a gauge block on wheel mounting surface confirmed they are all leaning. These hubs were now unusable for me, and I called to see if Mark would correct his work. All I got was excuses and that his job was correct although he acknowledged the studs were crooked when I first went to pick up my parts. No offer to help, no money coming back my way. He couldn't have cared less. I took in perfectly good, usable parts, and got back junk. Really sloppy work. Now I'm out $375 for work that I regret ever sending their way. Be assured that's the last money they'll get from me. Oh, forgot to mention, one of the hubs was machined .025" under the OD dimension I requested, potentially weakening this critical suspension part. Did I mention sloppy?

  dawn purtell (mill creek)
9 years ago
mark small's machine shop is great. we have been taking advantage of his services for 16 years now. mark is great, and everyone that works with/for him is great. very friendly, reasonable, quick turn around, and we have never had a problem. we own and operate a small honda/acura shop and mark does all of our machine work. i don't risk my business reputation lightly, and mark always makes us shine!

  Peter Kioko
10 years ago
Mark custom-lengthened a tractor PTO shaft for me.He did a great job, was pleasant to interact with, and even charged less than the initial quote.The shaft is working great for me now.Thanks Mark!

  Kasey Newins
3 years ago
So I made a call more than once to verify information in regards to prices and I was told more than once that the cost was going to be A and it ends up being B. The amount of money I was told was very excessive to the originally said price... I do not recommend this place at all... they are way to expensive and very unreasonable priced... Wont be coming back here ever again...

  Thomas Shaw
4 years ago
Mark has done two engines for me and it was money well spent. Reasonably priced and top quality.

  Daniel Peters
3 years ago
I was overcharged here. Promised a $500 qoute by an employee and charged nearly $800 at checkout... that s not how you run a buisness.

  Lee Ellison
a year ago
Built one of my 1st LS engines. They do really nice work.

  Brian Gott
5 years ago
Fast, efficient and quick turn around time. They are my "go to" Shop for Machine work.

  j Gebhart
9 years ago
quick turn around and reasonably priced